any suggestions on a carbon paddle repair job? the paddle has a big chip on the blade, but never damaged the fiber. opposite this side it has a crack a few inches long. i'm thinking about a wet/dry sandpaper down to the carbon, tape off the area, put a couple thin layers of g flex epoxy, and then sand it clean. the foam is closed cell so no worries there. anyone have any other ideas? much appreciated.
nate
carbon paddle repair
-
Shep
- ....
- Posts: 538
- Joined: Tue Jan 05, 2010 9:32 am
- Name: Paul Shepherd
- Location: Fayetteville, AR
Re: carbon paddle repair
You might through some 2" fiberglass tape on there too, Since epoxy isn't actually very strong by itself, but it sounds like a pretty good plan in general.
Shep
Shep
Paul Shepherd
"Believe me, my young friend, there is nothing - absolutely nothing - half so much worth doing as simply messing about in boats (said the water rat solemnly)." - Kenneth Grahame, The Wind in the Willows
"Believe me, my young friend, there is nothing - absolutely nothing - half so much worth doing as simply messing about in boats (said the water rat solemnly)." - Kenneth Grahame, The Wind in the Willows
-
Jim Krueger
- .....
- Posts: 1867
- Joined: Thu Jun 30, 2005 1:54 pm
- Location: Benton, AR
Re: carbon paddle repair
I'll go along with Shep. A little fiberglass tape will really make the most of the glue and adds so much strength to the repair overall.. After the patch is cured you can sand it some and then apply a little' thinned' coat of additional epoxy as a top coat and the repair will be almost transparent.
Best Regards
Jim Moose
Best Regards
Jim Moose
Re: carbon paddle repair
thank you much
Social Media
Who is online
Users browsing this forum: No registered users and 0 guests